Avocent CPS810 Guida Utente Scaricare il pdf (Pagina 13)

Review this section to familiarize yourself with the CPS. It describes the front

and rear panels, connector pinouts and device cabling.

About the CPS

The INIT button (Figure 1) can be used to remove configured information

from a CPS unit. The CPS stores nonvolatile data, such as IP addresses and

usernames, in a database in FLASH. This information can be erased by

pressing the INIT button.

Note that pressing the INIT button will interrupt operation of the CPS and cause

re-initialization to occur.

CPS Hardware

INIT: Pushing this button will restore the CPS to

factory defaults.

RESET: Pushing this button will reboot the CPS.

The 100MBps LED lights when the CPS is connected to a

100 Mbps LAN.

The TRAFFIC LED blinks when there is network traffic.

The LINK LED is lit when the CPS recognizes that it has a

connection to the network.

The ONLINE LED is lit (not blinking) when the CPS’s

self-test and initialization procedures have completed

successfully.

The POWER LED is lit when the CPS is connected to a

power source.

Figure 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 81 82

Nessun commento

Avocent CPS810 Guida Utente Pagina 13